Mount Thermostat To Wallplate; Advance Settings - Lennox T7300 Installation Instructions Manual

Mount Thermostat to Wallplate

1. Align the terminal screw blocks with the pins on the
back of the thermostat.
2 Push the thermostat straight onto the wallplate until
it snaps into place (see figure 14).
WA L L
Figure 14 − Mount Thermostat to Wallplate.

Advance Settings

The thermostat has advanced settings to match the
HVAC system. These settings can be adjusted to match
specific needs. Access to these settings is obtained as
follows:
1. From the main screen, press SYSTEM. Five blank
touch keys show on the bottom on the screen
between DONE and CANCEL.
2. Press and hold the two blank keys on either side of
the center blank key for approximately five seconds
(see figure 15).
3. The Setup Number displays to the lower−left area of
the screen. It is a four−digit code beginning with
zero. The current setting is displayed to the right.
NOTE: To cycle through the Setup Numbers, press the
up or down arrow.
Page 7