Service; Restarting Smart Hub; Multiple Smart Hub(S); Alternative Method - Lennox iComfort S30 Installation And Setup Manual

I. Once the commissioning is completed, exit the iComfort Mobile Setup
application.
J. Go to the mobile device's Wi-Fi tool and manually disconnect from the
Smart Hub.
K. Once disconnected the Smart Hub LED turns to a solid blue.
NOTE - If the connection between the iComfort Mobile Setup
application and Smart Hub is idle for 15 minutes, the Smart Hub will
auto-disconnect from the mobile device. Repeat procedures to
reconnect.

Service

To use iComfort Mobile Setup application as a service tool the commissioning
of the system must have already been completed.
A. Download and install the iComfort Mobile Setup application if not
already installed.
B. Go to the Smart Hub and touch the center Lennox button once.
C. The center ring LED will start blinking green for two minutes. During
that time the Smart Hub will broadcast its Wi-Fi identifier (SSID).
D. If this is the first time connecting to the target Smart Hub then go to your
mobile device's Wi-Fi connection tool and locate the Smart Hub Wi-Fi
broadcast identifier. The identifier (SSID) is Direct E300-5200 for
example. If your mobile device had already connected previously to
the target Smart Hub, then touch the applicable Smart Hub SSID on
the list and skip to step F.
NOTE - Refer to your mobile device's owners manual on how to use
your Wi-Fi Connection tool.
E. To connect to the Smart Hub use the last eight digits of the Smart Hub
SSID as the password (E3005200) for example.
F. Once connected to the mobile device the Smart Hub center ring LED
turns solid green.
G. Start the iComfort Mobile Setup application and make sure you
connected to the correct Smart Hub by checking the serial number.
H. Touch the remote in tab on the iComfort Mobile Setup application
home screen. This will take you to the dealer control center.
NOTE - If the system has not been commissioned it will go to
commissioning screen. If the system has already been commissioned
it will go to dealer control center.
I. Once servicing is completed, exit the iComfort Mobile Setup
application.
J. Go to the mobile device's Wi-Fi tool and manually disconnect from the
Smart Hub.
K. Once disconnected the Smart Hub LED turns to a solid blue.
NOTE - If the connection between the iComfort Mobile Setup
application and Smart Hub is idle for 15 minutes, the Smart Hub will
auto-disconnect from the mobile device. Repeat entire procedure to
reconnect.

Restarting Smart Hub

RESETTING SMART HUB - Pressing the center Lennox button for more than
five seconds will restart the SMART HUB.

Multiple Smart Hub(s)

When there are multiple Smart Hubs in the home and all connected to the same
router they will automatically connect through the Lennox Wi-Fi network to
each other and will be able to see each all thermostats from any other HD
Display.

Alternative Method

From the home screen, go to menu > settings > advanced settings > pair
Smart Hub to iComfort dealer mobile app selection. It will auto connect to
dealer app and start you at the dealer control center screen. The following
screen will appear and show the status of the connection. Once connected the
screen will automatically disappear.
18