Notifications; Tests; Diagnostics; Information - Lennox iComfort S30 Installation And Setup Manual

Notifications

See table 1 on page 45 for a complete list of all alert codes.

Tests

Verify Airflow Per Zone is the first screen to appear under this selection. If no
zoning is installed, zone airflow settings will be for zone 1 only. If zoning
equipment is detected by the system then zones 1 through 4 will be listed.
These screens allow for verification and modification of CFMs for blower,
heating and cooling circulation. Touch continue to proceed to the next screen.
Select Test to Run is the next screen to appear. Depending on hardware
present, various tests are available. By default all items to be tested are
enabled. Selecting a specific test will un-check the item. When a specific set of
tests are completed the results will be displayed on the screen next to the tested
item. Touch continue to proceed to the next set of test items. Once all tests are
completed press done to return to the touch tests to run screen. Touch the left
arrow at the top left side of screen to return to the Dealer Control Center.

Diagnostics

This screen allows the installer to test all major communicating components of
the system indoor unit (air handler or furnace), outdoor unit (air conditioner or
heat pump) and zoning control (if applicable). Pressing the stop diagnostics
button will pause the diagnostic function.
Touch the left arrow at the top left side of screen to return to the Dealer Control
Center.

Information

Dealer — Information
The dealer information screen will appear. The next screen will be for dealer
information. Here either the dealer ID or phone number can be added. Once the
system is connected to the Internet, the remaining information is automatically
populated. Not all information for this screen will be viewable. Touch and hold
and then drag up to access the remaining information on the screen.
Information Required: Dealer ID and / or dealer phone number. Information
that can be manually entered is name, email website, dealer address which
includes address 1, address 2, city state and zip/postal code. Once completed,
Touch the left arrow at the top left side of screen to return to the Dealer Control
Center.
IMPORTANT: ADDING DEALER INFORMATION WILL ENSURE THE
®
ICOMFORT S30 IS ASSOCIATED WITH YOUR DAVENET ACCOUNT
WHEN CONNECTING TO THE LENNOX SERVER.
Warning Screen: If neither the dealer ID or phone number is provided, a
warning screen will appear. The warning screen will provided information on the
limitation imposed on the system if this information is missing. Touch no to
return to the above screen to complete the information requested or press yes
to continue.

General Information

On this screen general information needs to be verified or changed. Touch any
item to change its contents. A pop-up screen will appear that will allow the
information to be added or changed.
Information Required:
1. Select desired language (ENGLISH, FRANÇAIS, ESPAÑOL).
2. Select country / region.
3. Select time and date which includes time, date, time zone, daylight savings
time (ON/OFF)
4. Temperature unit (Fahrenheit or Celsius).
Once completed press continue.

Home Address

On this screen general information needs to be verified or changed. Touch any
line item to change its contents. Information to be added is address 1, address
2, state, city and zip/postal code.
Complete the requested information and press the continue button.
33