Smart Hub Installation - Lennox iComfort S30 Installation And Setup Manual

CAUTION
1) Battery may need to charge before operation. Once the display
is connected, instructions may appear within 15 seconds with
further detail.
2) TO AVOID BREAKING THE GLASS DISPLAY
a. Do not apply force directly to the glass display
b. Holding the display horizontally
i. Center the display cavity on the base
ii. Press both sides equally until the snaps engage
3) AVOID EXCESSIVE FORCE TO THE CLASS DISPLAY
USE SMART HUB AS TEMPLATE TO MARK DESIRED MOUNTING LOCA­
TIONS ON WALL OR STUD.
A
CAUTION: DO NOT OVERTIGHTEN LOWER MOUNTING SCREW, MAY
DAMAGE SMART HUB.
THROUGH-HOLE
FRONT

Smart Hub Installation

1. Use the following procedure to install the Smart Hub controller. Refer to
figures 3 through 12 for making control wiring connections.
2. Mount the Smart Hub near the indoor unit using field-provided fasteners.
3. Unfold both antennas to the vertical position. Adjustments may be required
to optimized transmitting and receiving.
NOTE - DO NOT install the Smart Hub to indoor unit, duct work or equipment
that could induce vibration to the module. Install Smart Hub on flat surface away
from indoor unit to minimize vibration. Securing module to a wall stud is
desirable. If installed on metal surface other than above, antennas need to be
perpendicular to the metal surface.
STRIP 1/4" INSULATION FROM
B
END OF EACH CONTROL WIRE
1/4"
KEYHOLE
.
MAKE CONNECTIONS TO SMART HUB
C
USING WIRING DIAGRAMS PROVIDED
STARTING WITH FIGURE 3 ON PAGE
7.
REAR
Figure 2. Smart Hub Installation
6
SECURE SMART-HUB TO
D
WALL WITH
FIELD-PROVIDED
FASTNERS
SMART HUB WIRE
CONNECTORS.
TOUCH LEVER BACK AND
INSERT WIRE THROUGH
HOLE LOCATED ON
BOTTOM SIDE OF
CONNECTOR. RELEASE
LEVER TO SECURE WIRE.
18-GAUGE THERMOSTAT
WIRE