Thermostat (Hd Display); Zoning Control; Add / Remove Equipment; Reset - Lennox iComfort S30 Installation And Setup Manual

Thermostat (HD Display)

This screen provides information concerning model number, serial number,
hardware revision, software revision, language support and equipment type
name.
Screen Locked
Options are unlocked, partially locked and locked. Default is unlocked.
Display Outdoor Weather
Options are on and off. Default is off.
Display Air Quality
Options are on and off. Default is off. Air Quality is displayed under the weather
display. Touch the Weather icon on the home page to see the current air quality.
Outdoor Temperature
Options are Internet, sensor or off. Default is sensor.
Display Indoor Humidity
Options are on and off. Default is off.
Options are off, weather, power save and picture. Default is off.
Auto Brightness
Options are on and off. Default is off.
Brightness Value
The brightness range is 0 - 100. Default 80. Touch either the + or - button to
increase or decrease the setting.
Proximity Control
Options are ON and OFF. Default is OFF. Is used to wake-up the display from
screen saver mode when motion near the HD Display is detected.
Options are ON and OFF. Default is OFF. This allows a wider low and high
temperature. Normal range is 60 to to 90°F. When this parameter is set to ON,
the range is 40 to 100°F. This feature can also be set through the user interface
setting screen. From the home screen go to menu > settings > heat & cool (or
it may be just heat or cool) > wider set-point range.
Reset thermostat
Resets the thermostat settings to factory default.
About
Screen Saver
Wide Setpoint
This provides information on unit code, language supported, equipment type
name, control software revision, control model number, control serial number,
control hardware revision, protocol revision number, device product level,
24VAC average power consumption, 24VAC peak power consumption,
compatible devices list, application code memory size, micro-controller part
number, max number of zones, supported damper types, number of damper
positions, zone temp sensor 1, zone temp sensor 2, zone temp sensor 3 and
zone temp sensor 4.
Equipment Name
A unique name can be assigned to this component. Name can be up to 29
characters. Name can consist of letters, numbers, special characters and
spaces.
Zones 1 through 4 Temp Reading Calibration
Allows adjustment to temperature reading displayed on zone thermostat.
Reset Zoning Control
Any installer modifications under the zoning control tab will be reset back to the
factory defaults if the reset zoning control option is used.

Add / Remove Equipment

This selection allows the installer to add or remove non-communicating 24VAC
controlled equipment such as outdoor units, humidifiers and dehumidifiers.
Using this option will reset all equipment back to its original factory default
settings. The installer setup sequence will start as well.
Restart Smart Hub
restarts the Smart Hub.
Re-configure System
Resets the system and re-discover all iComfort components.
Reset HVAC Equipment
Resets all HVAC equipment.
Reset Thermostat
Resets thermostat to factory default settings.
Factory Reset Smart Hub
Resets all Smart Hub parameters back to factory default.
32

Zoning Control

About

Reset