Stacker Adjustment; Paper Width Adjustment - Konica Minolta BizHub Pro 1050 User Manual

04 Stacker Adjustment

01 Paper Width Adjustment

Perform this adjustment when output sheets are not aligned in a perpendicular
position to the direction of paper feed processed by the LS-501/502 Large Capacity
Stacker.
Procedure
1 Touch Adjustment - 02 Finisher Adjustment - 04 Stacker Adj.
2 Touch 01 Paper Width Adjustment to display the Paper Width Adjustment
Screen.
3 Touch the COPY tab to display the Copy Screen.
4 Specify A3 then press [Start]. A sample pattern (No. 16) will be output.
5 If output sheets are misaligned, touch the ADJUSTMENT tab.
6 Touch Next or Back to select the desired Stacker No..
7 Use the touch panel keypad to enter the desired adjustment value, then touch
Set.
Available range: -20 (narrow) to +20 (wide), 1 step = 0.1 mm
8 If the desired result cannot be obtained, touch the ADJUSTMENT tab.
9 Repeat steps 3 to 8 until the desired result is obtained.
10 Touch Return to restore the Stacker Adjustment Mode Menu Screen.
2-38