Controller Nic Setting - Konica Minolta BizHub Pro 1050 User Manual

02 Controller NIC Setting

Specify the controller settings. Various default settings or network settings can be
customized as required.
List of the Network Settings
Specify the settings for connecting a network printer and network scanner, and the
settings for TCP/IP, RAW port numbers, IP Filter (permission/denial), and ping.
Specific setting and Description
01 TCP/IP
TCP/IP
Specify enable or disable TCP/IP.
DHCP
Specify enable or disable Dynamic Host Configuration
Protocol (DHCP). If Enable is selected, the IP
address is automatically obtained from the DHCP
server, in which case it is not necessary to enter it.
IP Address
Specify the IP address.
Subnet Mask
Specify the subnet mask.
Default Gateway
Specify as required.
DNS Server1 to 3
Specify DNS server addresses.
DNS Host Name
Specify the DNS host name.
DNS Domain Name
Specify the DNS domain name.
LPD
When Enable is selected, LPD/LPR printing becomes
available.
Network Speed
Specify the network transfer rate.
TCP/IP RAW port settings (1 to 6)
Specify RAW port numbers and to be used or not.
TCP/IP Filter permission settings *
Specify to use the permission settings or not, and the
range in which to permit connections.
TCP/IP Filter denial settings *
Specify to use the denial settings or not, and the
range in which to deny connections.
Network Test Ping Address
Perform ping.
*1: If the range of the permission setting is the same as that of the denial setting, the latter setting overrides
the former.
*2: The functions that are affected by the permission and denial settings are as follows:
HTTP servers (PSWC, IPP), HTTP servers (PSWC with SSL), printing over the network (LPD, RAW
Port, SMB), FTP servers (access to Scan to HDD jobs), SNMP
5-36
1 2
*
1 2
*
Setting options (underlined: default)
Enable/Disable
Enable/Disable
0.0.0.0 (0 - 255)
0.0.0.0 (0 - 255)
0.0.0.0 (0 - 255)
0.0.0.0 (0 - 255)
**********
Varied from machine to machine.
Max. 63 characters combining
symbols and alphanumerics can
be used.
Max. 63 characters combining
symbols and alphanumerics can
be used.
Enable/Disable
Auto Negotiation/10M Half Duplex/
10M Full Duplex/100M Half
Duplex/100M Full Duplex
Use/Not Use
(Set between 1 - 65535.)
On/Off
0.0.0.0 - 0.0.0.0 (0 - 255)
On/Off
0.0.0.0 - 0.0.0.0 (0 - 255)
Max. 255 characters combining
symbols and alphanumerics can
be used.
p.5 - 45