Table of Contents
Advertisement
Preparing the thread guide
assembly
Assemble the thread guide assembly. Locate the
included Phillips screwdriver.
a
Remove the two screws from the thread
guide assembly support.
b
Slide the thread guide support onto the
machine, and then lightly tighten the screw,
until the thread guide support is secure.
c
Tighten the screw on the opposite side of
the thread guide assembly in the same
manner.
Note
• Do not apply extreme force when moving
the thread guide assembly support and the
thread guide.
• Be sure to tighten each screw well enough
that the thread guide assembly support and
the thread guide are secured.
Attaching the embroidery frame
holder a
Attach the embroidery frame holder to the
carriage.
a
Use the embroidery frame holder
appropriate for the embroidery frame that
you are using. (Refer to "Embroidery frame
types and applications" on page 74.)
b
Remove the two thumb screws of the
embroidery frame holder.
1 Thumb screws
2 Corner covers
c
Align the holes in the embroidery frame
holder with the pins on the frame-mounting
plate of the carriage.
1 Pins on the frame-mounting plate
2 Holes in the embroidery frame holder
GETTING READY
1
21
Advertisement
Chapters
Table of Contents
