Brother 882-T51 Operation Manual page 45

Note
• The embroidery frame indicators show all
embroidery frame sizes in which the
embroidery pattern can be sewn. Be sure to
use an embroidery frame of the most
suitable size. If the embroidery frame that is
too large is used, the pattern may be
misaligned or the fabric may pucker. (Refer
to "Correctly Using the Embroidery Frames"
on page 74.)
b Loosen the screw on the outer frame.
1 Screw
c Place the fabric with the right side up on
top of the outer frame.
• The outer frame does not have a front or back side.
Either side can be used as the front.
d Press the inner frame into the outer frame.
• Be sure that there are no wrinkles in the fabric or
stabilizer after they have been positioned in the
embroidery frame.
e Lightly tighten the screw, and then pull the
edges of the fabric.
EMBROIDERING TUTORIAL
f Securely tighten the screw, and then check
that the fabric is taut.
• After securing the fabric, lightly tapping it should
produce a drum-like sound.
• Firmly clamp together the inner and outer frames so
that the bottom of the inner frame is lower than the
bottom of the outer frame.
1 Inner frame
2 Outer frame
3 Bottom of inner frame
• Using the included screwdriver (large), firmly tighten
the screw.
1 Screwdriver (large)
The amount that the fabric is stretched and the use
of stabilizer material differ depending on the type
of fabric being embroidered. Try various methods
to achieve the best embroidering results. (Refer to
"Hooping techniques" on page 162.)
2
43