Easily Changing The Thread Spools; Using The Spool Net - Brother 882-T51 Operation Manual

■ Using the spool net

When using metallic thread or any other strong
thread, place the included spool net over the spool
before embroidering.
If the spool net is too long, fold it once to match the
size of the spool before placing it over the spool.
It may be necessary to adjust thread tension when
using the spool net.
1 Spool net
2 Thread

Easily changing the thread spools

When replacing the thread spools, it is necessary
to re-thread the upper thread. However, the thread
spools can easily be changed when replacing a
thread spool whose thread is correctly threaded
through the machine.
a Cut the thread between the thread spool
and the thread guide.
1 Thread cutter
b Change the thread spool.
EMBROIDERING TUTORIAL
c Tie the end of the thread on the new spool
with the end of the thread remaining from
the previous color.
d Pull out the old thread just after the needle
bar thread guide.
Continue pulling the thread until the knot is above the
needle. Cut the knot.
e Use the automatic threading mechanism to
thread the needle with the new thread.
(Refer to "Threading the needle" on
page 51.)
→ This completes the changing of the thread spool.
Note
• When pulling out the thread, do not pull the
knot through the eye of the needle. If the
knot is pulled through the eye of the needle,
the needle may be damaged.
2
53