Table of Contents
Advertisement
■ The frame came out from the
carriage
Make sure that the positioning pins are placed into
the frame's positioning slot and hole. (Refer to
page 44.)
To insure proper registration of pattern for
embroidery, turning off the machine and turning it
back on will allow the embroidery arm to reset it's
registration points.
■ Cancel the current pattern and start
again
Select the "Home" key on the upper right of the
screen. The pattern and all information will be
deleted. (Refer to "Understanding the screens" on
page 30.)
USB connectivity
You can perform many functions using the USB
ports on the machine. Connect the appropriate
devices according to the features of each port.
1 USB port
2 USB port for computer
Note
• The processing speed may vary by port
selection and quantity of data.
• Do not insert anything other than USB
media into the USB media port. Otherwise,
the USB media drive may be damaged.
68
■ Using USB media or embroidery
card Reader/USB card writer
module*
When sending or reading patterns using the USB
media or the embroidery card Reader/USB card
writer module*, connect the device to the USB port.
*
If you have purchased the PE-DESIGN Ver5 or later,
PE-DESIGN NEXT, PE-DESIGN Lite or PED-BASIC,
you can plug the included USB card writer module
into the machine as an embroidery card reader, and
recall patterns.
1 USB port
2 Embroidery card Reader/USB card writer module*
or USB media
Note
• Use only an embroidery card reader
designed for this machine. Using an
unauthorized embroidery card reader may
cause your machine to operate incorrectly.
• Embroidery patterns cannot be saved from
the machine to an embroidery card inserted
into a connected USB card writer module.
Memo
• USB media is widely used, however some
USB media may not be usable with this
machine. Please visit our website ( http://
support.brother.com ) for more details.
• Depending on the type of USB media being
used, either directly plug the USB device
into the machine's USB port or plug the
USB media Reader/Writer into the
machine's USB port.
Advertisement
Chapters
Table of Contents
