Table of Contents
Advertisement
Hold the needle changing tool and press the end of the
needle changing tool 1 in to extend the needle-
mounting clamp 2. Attach the clamp to the needle,
and then release the pressed area to clamp the needle.
To unclamp the needle, press 1 again.
1 End of the needle changing tool
2 Needle mounting clamp
d
While holding the needle in place with your
left hand, tighten the needle set screw.
Use the Allen screw driver to turn the needle set screw
clockwise.
CAUTION
• Be sure to insert the needle all the way up until
it touches the needle bar stopper and securely
tighten the needle set screw with the Allen
screw driver, otherwise the needle may break
or the machine may be damaged.
• If the needle is not fully inserted, the hook of
the automatic threading mechanism will not
pass through the eye of the needle during
automatic needle threading, and the hook may
bend or the needle cannot be threaded.
• If the hook of the automatic threading
mechanism is bent or damaged, contact your
authorized Brother dealer.
OTHER BASIC PROCEDURES
3
73
Advertisement
Chapters
Table of Contents
