Setting Up The Machine - Brother 882-T51 Operation Manual

Setting up the machine

When setting up the machine, adjust the legs so
that the machine is steady.
a Make sure that all packing tape affixed to
the machine is peeled off and that all
packing material is removed.
b Set up the machine while making sure that
there is sufficient space around it.
More than 511 mm More than
150 mm (20-15/128 150 mm
(5-29/32 inches) (5-29/32
inches) inches)
c Adjust the legs so that the machine is
steady.
Use the included wrench to loosen the lock nut on the
leg that you wish to adjust.
1 Lock nut
2 Adjustable foot nut
→ The foot can be turned.
20
d
More than
50 mm
(2 inches)
587 mm
(23-7/64 inches)
e
More than
350 mm
(13-3/4 inches)
f
Use the included wrench to turn the
adjustable foot nut on the foot.
Turning the nut in direction 1 lengthens the leg;
turning the nut in direction 2 shortens the leg.
1 Adjustable foot nut
• Adjust all four legs so that they securely contact the
desk or table.
After adjusting the legs to the desired
length, use the included wrench to tighten
the nuts.
1 Lock nut
Press down on each corner of the
embroidery machine to check that it is
stable.
If it is still unstable, perform steps
to adjust the legs.
c e
through again