Brother 882-T51 Operation Manual page 38

k Press .
→ The bobbin starts winding. The bobbin stops rotating
when bobbin winding is completed. The bobbin
winding switch will automatically return to its
original position.
Note
• changes to
is winding. Press
before the bobbin is fully wound.
• Stay near the machine while winding the
bobbin to make sure the bobbin thread is
being wound correctly. If the bobbin thread
is wound incorrectly, press
immediately to stop the bobbin winding.
Memo
• You can change the winding speed by
pressing (to decrease) or
increase) in the bobbin winding window.
• Press to minimize the bobbin
winding window. Then, you can perform
other operations, such as selecting a stitch
or adjusting the thread tension, while the
bobbin is being wound.
• Press
screen) to display the bobbin winding
window again.
36
while the bobbin
if you want to stop
(to
(in top right of the LCD
l Cut the thread with the cutter and remove
the bobbin.
1 Cutter
Note
• When removing the bobbin, do not pull on
the bobbin winder seat. Doing so could
loosen or remove the bobbin winder seat,
and could result in damage to the machine.
CAUTION
• Check that the bobbin
thread has been wound
correctly, otherwise the
needle may break or the
thread tension will be
incorrect.
• Be sure to clean the bobbin case each time
that the bobbin is changed. Thread wax and
dust easily collect around the hole in the
tension-adjusting spring on the bobbin case,
resulting in an incorrect thread tension. For
details, refer to "Cleaning the bobbin case" on
page 166.
• Be sure to check the tension of the bobbin
thread each time that the bobbin is changed.
• Depending on the bobbin thread type, the
tension of the bobbin thread may differ. Be
sure to check the tension of the bobbin thread
and adjust the tension if necessary.
For a metal bobbin, use both weights, large (L)
and small (S).
For detailed instructions on how to adjust the
bobbin tension, refer to page 91.
1 Weight (L) (Part Code: XC5974-151)
2 Weight (S) (Part Code: XC6631-051)