Brother 882-T51 Operation Manual page 54

b Pull out about 150 mm (6 inches) of thread.
Then, as shown in the illustration, pass the
thread under the fork of the automatic
threading mechanism from the right, and
then catch the thread with the hook that
passes through the eye of the needle.
1 Hook
2 Fork
Note
• When catching the thread with the hook, be
careful that the thread does not become
loose.
c Pass the thread under the guide on the
presser foot.
1 Guide on presser foot
2 Notch in guide on presser foot
• Make sure that the thread securely passes through the
notch in the guide on the presser foot.
d Securely pass the thread through the groove
in the thread cutter, and then lightly pull
the thread to cut it.
1 Groove in thread cutter
52
Note
• If the thread is not correctly passed through
the groove in the thread cutter, the
message "Wiper error" appears and the
needle cannot be threaded. Be sure to
securely pass the thread through the
groove.
• If enough thread is not pulled out, the
thread cannot be pulled through the thread
cutter.
e Press the "Automatic Threading" button.
• The threader moves back away from the needle. The
thread is pulled through the needle eye.
• The wiper comes out and catches the thread between
the needle and the threader.
• The threader goes back to the original home position.
This completes the upper threading.
Note
• If the thread is not taut, it may come out of
the thread tension disc. After upper
threading is finished, check again to make
sure that the thread is correctly passed into
the thread tension disc. (Refer to step
page 50.)
e
on