Error Messages - Brother 882-T51 Operation Manual

Error messages

If the "Start/Stop" button is pressed while the machine is not correctly set up or if an incorrect operation is
performed, the machine stops and informs you of the error with a buzzer and an error message. If an error
message appears, correct the problem according to the instructions in the message.
To close the message, touch
appears again, consult your nearest authorized Brother dealer.
Some malfunction occurred.
The installed embroidery frame is too
small.
Check which embroidery frames can be
used, and then install a larger
embroidery frame. (Refer to page 42.)
or perform the correct operation, then touch
There are too many characters in the
curved text arrangement for the selected
embroidery frame.
Change the text arrangement or the
embroidery frame.
The upper thread broke, the thread
came out of the thread tension disc or a
thread guide, or the machine is not
threaded correctly.
Check that the thread passes under the
upper and middle thread guides, and
correctly thread the upper thread. (Refer
to page 48.) If the thread is not broken,
clean the thread guides and the tension
unit. (Refer to page 166.)
APPENDIX
. If the message
The pattern data that you tried to recall
is invalid.
Check the pattern data.
• The pattern data is damaged.
• You tried to recall data created using
another manufacturer's data design
system. (Refer to page 104.)
Turn the machine off, then on again to
return it to its normal condition.
The bobbin thread broke or ran out.
Check that there is thread on the bobbin
and that approximately 50 mm (2
inches) of thread has been pulled out,
and then re-install the bobbin. (Refer to
page 33.)
7
177