Table of Contents
Advertisement
Changing the Embroidering Position
When the embroidery machine is purchased, it was adjusted so that the beginning of the stitching was
from the center of the pattern. Therefore, move the frame and adjust the embroidering position so that the
center of the pattern aligns with the needle drop point at the embroidering position. In addition, the angle
of the entire pattern can be adjusted if the fabric cannot be hooped evenly within the embroidery frame
and the pattern is positioned at an angle on the fabric.
a
Touch
,
,
,
the embroidering settings screen.
Move the embroidery frame so that the needle drop
point is at the center of the area where you wish to
embroider. The red pointer light indicates the needle
drop point when you set the "LED pointer" to "ON" in
the settings screen. For details on the settings screen,
refer to "Using the Settings Key" on page 142.
→ The embroidery frame moves in the opposite
direction of the arrow.
→ The pattern in the pattern display area moves in the
same direction of the arrow.
1 Shows the vertical distance moved
2 Shows the horizontal distance moved
• Touch
to move the embroidery frame back to its
original position (where the center of the embroidery
frame is aligned with the needle drop point at the
embroidering position).
,
,
,
and
in
1 2
OTHER BASIC PROCEDURES
The pattern can also be dragged by selecting it directly
in the screen with your finger or the touch pen.
Adjusting the angle
Depending on the type of fabric being
embroidered, it may not be possible to stretch the
fabric in the embroidery frame at the desired
angle. In this case, adjust the angle of the pattern
so that it is correctly positioned on the fabric.
a
Touch
.
The screen shown below appears.
1
2
3
4
5
6
Example: Original angle
3
7
8
9
83
Advertisement
Chapters
Table of Contents
