Unpacking The Rmx - Polycom RealPresence 4000 Installation And Configuration Manual

Obtain the following information from your network administrator:
• IP addresses, Subnet Mask and Default Gateway IP address
(optional) for the RMX Control Unit and RMX Shelf Management.
• IP addresses for the RMX Signaling Host and Media cards.
• Gatekeeper IP address.
• SIP server IP address, if applicable.
If ISDN/PSTN is installed in your conferencing environment, obtain the
following information from your ISDN/PSTN Service Provider:
• Switch Type, Line Coding and Framing, Numbering Plan and
Numbering Type.
• Dial-in number range
If the RMX is connected to the public ISDN Network, an external
CSU or similar equipment is needed.
When you receive the RMX packing case, inspect the equipment for
1
damage and verify that the components match the packing slip.
Unlock and lift the RMX top cover.
2
Make sure that the Installation Accessories kit contains the power
cables and a USB Key and that the Rack Installation Accessories kit
contains the accessories for installing the RMX in 19" racks. For
details, see the Getting Started Guide, "Telescopic Rail Runners
Accessory Kit" on page 2-9.
Remove the boxes that are placed on the top Stratocell® and the top
3
Stratocell® and open the anti-static plastic bag wrapping the RMX.
Holding the handle on each side, lift the RMX from the box, and
4
place it on a flat surface or in a rack. Remove any packaging
material prior to positioning the RMX.
Attention:
Two people are required to lift the MCU out of the box and when
installing it in a rack.
2
Preparations
.

Unpacking the RMX