Polycom RealPresence 4000 Installation And Configuration Manual page 5

• On the RTM IP-4000:
— Connect the Management Network cable to LAN 2.
— Connect the Signalling cable to LAN 3.
— Connect the Shelf Management cable to LAN 6.
• For each installed RTM LAN - Connect the LAN cable to LAN 2.
• For each installed RTM ISDN:
— Connect the E1/T1 cables to their PRI Ports.
— Connect the LAN cable to LAN 1.
•
LAN 4, LAN 5 and the Serial ports are only for debugging and
not for customer use.
•
Do not remove the protective plastic caps from LAN 1, LAN 4
and LAN 5 ports.
Insert the USB Key with the modified IP addresses into the USB
1
port on the back panel.
Turn ON the power by pressing on the power switch located on the
2
rear panel of the RMX.
The FAN STATUS and PWR STATUS LEDs turn ON.
System power-up sequence may take approximately 10 minutes.
During this time, the parameters in the lan.cfg file are uploaded
from the USB key to the RMX's memory and applied during the
power-up sequence.
Wait for the upload process to complete. Initially, all the ERR/
RDY/ACT LEDs flicker and flash. Upload is completed when all
the LEDs turn off and only the red ERR LED (on the CTNL unit)
remains ON.
It remains ON until the Default IP Network Service is configured.
Do not remove the USB key from the RMX until the connection
with the RMX is established.
First Entry Power-up
5