Konica Minolta bizhub 500 User Manual page 280

Application Functions
? Is it available to select [Frame] and other four keys ([Top], [Left],
[Right], and [Bottom]) at the same time?
% No. Use [Frame] only for specifying the same erasure amount col-
lectively for all four sides.
Do you want to change the currently entered value using control
?
panel keypad?
% Press [C] (Clear) on the control panel, then enter the correct value.
What if the value just entered is out of available range?
?
% The Input Error message will be displayed. Press [C] (Clear) on the
control panel, then reenter the correct value.
Is it available to change the side to be erased even if the erasure
?
amount is already specified?
% No.
6
Touch [OK] to return to the Application Screen.
– Touch [Cancel] on the Erase Screen to cancel the setting change.
7
Select additional copy conditions, as desired.
8
Press [Start] on the control panel.
The machine will start scanning the original, then printing when ready
for output.
Note
To release the selected application function, touch [OFF].
To release all the application functions, touch [Reset].
To resume the initial setting for all settings including application function,
press [Reset] on the control panel.
Note
If no other setting is desired, the copy job can be started using the set-
tings currently specified without touching [OK] to return to the Application
Screen or Basic Screen.
bizhub 500/420
5
5-71