Distance Adjustment - GRAPHTEC CE5000-120AP User Manual

4.12 Distance Adjustment

This function corrects any deviation in the length of cut or the plotted line segments, which occurs depending
on the medium being used. The adjustment value for the deviation is specified as a percentage of the total
distance. For example, a setting of 0.05% adjusts a distance of 2 m (2,000 mm) by +1 mm (2000 x 0.05% = 1
mm), to become 2,001 mm. Eight different cutter-pen condition-setting areas can be set on or off separately,
allowing different settings to be made in order to suit the medium used.
(1) Press the
C L E A R B U F F E R
(2) Press the
F E E D & C U T
B L A D E W A R E S E T U P
(3) Press the
P E N U P / D O W N
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
(4) Press the
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
T E S T
(5) Press the
(6) Select the condition-setting area to be set to "ON" (refer to "Selecting Cutter-Pen-
(7) Either press the
(8) Select "X" or "Y" using the
(PAUSE) key to switch to PAUSE mode.
(NEXT) or
A D V A N C E D F U N C .
(ENTER) key, and then press the
until the following menu is displayed.
D I S T A N C E A D J U S T
(ENTER) key to display the distance adjustment menu. The
numbers "1" to "8" indicate the cutter-pen condition-setting areas, and those that
are set on are indicated with the s symbol to the left.
1 2 3 4 5 6 7 8
Use the or key to move the cursor to select the required condition-
setting area. Press the
and then press the
(NEXT) or (PREV.) key.
(PAUSE) key to cancel PAUSE mode.
Condition Setting Areas" on page 3-6).
5 1 5 U 0 2 0 3 0 1
(ENTER) key or use the
right, and then press the
X = 0 . 0 0 % Y = 0 . 0 0 %
decrease the setting within the range of "-2.00%" to "+2.00%," and then press
the (ENTER) key to confirm. If the condition-setting area is set for
TANGENTIAL mode, the TANGENTIAL-mode setting will be displayed. Press
(ENTER) again. To cancel the selection(s), press the
key.
CHECKPOINT
This setting is retained in the memory even when the power is turned off.
(PREV.) key until the following menu is displayed.
or key to display or not display thes symbol,
(ENTER) key to confirm. To cancel, press the
key to display the following menu.
or key. Use the
Function Settings and Operations
(NEXT) or (PREV.) key
key to move the cursor to the far
or key to increase or
(NEXT) or (PREV.)
4-15