Setting The Paper Load Function - GRAPHTEC CE5000-120AP User Manual

4.34 Setting the PAPER LOAD Function

This function is used to set the number of pre-feed operations (an operation that leaves traces of the grit
rollers on a medium to prevent it from slipping during a cutting or plotting operation) to be performed on a
length of medium that has been pulled out from a roll.
The pre-feed function is performed repeatedly for the specified number of times after the PAPER READY
TIME ("4.33 Setting the PAPER READY TIME") operation has been completed.
This setting becomes effective when ON has been selected for the INITIAL FEED setting.
(1) Press the
C L E A R B U F F E R
(2) Press the
F E E D & C U T
B L A D E W A R E S E T U P
P E N U P / D O W N
(3) Press the
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
(4) Press the
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
T E S T
(5) Press the
(PAUSE) key to switch to PAUSE mode.
(NEXT) or
S E T U P M E N U
(ENTER) key, and then press the
until the following menu is displayed.
P A P E R L O A D
(ENTER) key to display the PAPER LOAD setting.
P A P E R L O A D
Press the or key to specify the number of pre-feed operations in the
range from "0" to "5", and then press the
To cancel the selection, press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• The setting is retained in the internal memory even when the power is turned off.
• Plotting or cutting of data that has been sent to the plotter during the PAPER READY
TIME operation is performed immediately after the PAPER READY TIME and PAPER
LOAD operations have been completed.
(PREV.) key until the following menu is displayed.
0
(ENTER) key.
(NEXT) or
Function Settings and Operations
(NEXT) or (PREV.) key
(PREV.) key.
4-39