Setting The Length Unit - GRAPHTEC CE5000-120AP User Manual

Function Settings and Operations

4.24 Setting the LENGTH UNIT

This function specifies the units for coordinates displayed in millimeters or inches.
C L E A R B U F F E R
F E E D & C U T
B L A D E W A R E S E T U P
P E N U P / D O W N
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
T E S T
4-28
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or
A D V A N C E D F U N C .
(3) Press the (ENTER) key, and then press the
until the following menu is displayed.
L E N G T H U N I T
(4) Press the (ENTER) key to display the length-unit menu.
L E N G T H U N I T
Press the or
(ENTER) key to confirm. To cancel the selection, press the
(PREV.) key.
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
(PREV.) key until the following menu is displayed.
m m
key to select "mm" or "inch," and then press the
(NEXT) or (PREV.) key
(NEXT) or