Specifying The Space Rear Distance - GRAPHTEC CE5000-120AP User Manual

Function Settings and Operations

4.18 Specifying the SPACE REAR Distance

The SPACE REAR function specifies the trailing margin of the medium. When cross-cutting is performed on
the basis of the TIMEOUT or SEPARATOR setting, cross-cutting is initiated at a coordinate position which is
the maximum +X-axis position plotted plus the distance specified by the SPACE REAR setting.
C L E A R B U F F E R
F E E D & C U T
B L A D E W A R E S E T U P
P E N U P / D O W N
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
T E S T
4-22
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or
A D V A N C E D F U N C .
(3) Press the (ENTER) key, and then press the
until the following menu is displayed.
S P A C E R E A R
(4) Press the (ENTER) key to display the SPACE REAR setting.
S P A C E R E A R = 1 2 m m
Press the or
range of "7 mm" to "30 mm", and then press the
the selection, press the
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
(PREV.) key until the following menu is displayed.
key to specify the distance of the trailing margin within the
(NEXT) or (PREV.) key.
(NEXT) or (PREV.) key
(ENTER) key. To cancel