GRAPHTEC CE5000-120AP User Manual page 20

(5) Attach the media guide bracket to the underside of the front panel. Loosen the two decorative
screws that are attached to the underside of the front panel (one on each side) by two or three
turns, slot the bracket in, and then tighten the screws.
CAUTION
• When attaching the media guide bracket, take care not to drop it on your feet or on any other
parts of your body. Make sure that the decorative screws and pins are fitted into the U-shaped
cutouts on the media guide bracket.
• When loosening or tightening the decorative screws, take care not to injure yourself on any parts
in their vicinity.
(6) Attach the alignment shaft to the stand tops. Loosen the attached bindhead screws A (M4) two
or three turns, and then insert the brackets on the end of the shaft using the elongated screw
holes. Remove the fixing tape from the alignment shaft and then push the shaft in until it
contacts the curved area indicated by "a" in the figure below. Tighten the A (M4) bindhead
screws. When the shaft has been attached, tighten the bindhead screws B (M4), and check
that the shaft does not rotate. The bindhead screws B are screws to prevent the shaft from
rotating. Tighten the screws so that the holes in the shaft are positioned approximately in the
center in the horizontal direction and at the top and bottom in the rotation direction.
a
Alignment shaft
Fixing tape
Media guide bracket
stand top
Bracket
Bindhead screws B (M4)
Pin
Decorative screw
a
stand top
Bindhead screws A (M4)
Introduction
a
1-9