Parts Names And Functions; Front View - GRAPHTEC CE5000-120AP User Manual

1.2 Parts Names and Functions

Front View

Cutting mat .............. Cutting or plotting is performed on this mat.
Grit roller ................. Feeds the medium backward or forward.
Pen carriage ............ Moves the cutter pen to the left and right.
Cutter pen holder .... Hold the cutter pen and moves it up and down.
Pen holder ............... Holds the pen and moves it up and down.
Media set lever ........ Raises or lowers the push rollers during loading of a medium.
Control panel ........... Used to operate the cutting plotter and set functions.
Pen station .............. Used to mount the pen before it is used.
Stoppers .................. Used to hold a roll medium in place (left and right, one each).
Stock shaft .............. Used to load roll media.
Push rollers ............. Pushes the medium against the grit rollers.
Serial (RS-232C) interface connector
........................ Used to connect an RS-232C serial interface cable.
USB interface connector
........................ Used to connect a USB cable.
Cutter pen holder
Cutting mat
Grit roller
Stopper
Stock shaft Push rollers
Pen holder
Pen carriage
Media set lever
Pen station
Control panel
Serial (RS-232C)
interface connector
USB
interface connector
Introduction
1-3