Sorting Settings - GRAPHTEC CE5000-120AP User Manual

4.17 Sorting Settings

This function sorts the cutting/plotting data stored in the memory so that cutting is performed last when both
cutting and plotting operations are performed. This is useful for data requiring a large number of movements
on the drawing with the pen raised. If the data received has been sorted using the application software,
sorting the data using the cutting plotter may require additional time. Turning this function off may speed up
the process.
(1) Press the
C L E A R B U F F E R
(2) Press the
F E E D & C U T
B L A D E W A R E S E T U P
P E N U P / D O W N
(3) Press the
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
(4) Press the
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
A D V A N C E D F U N C .
(5) Press the
S E T U P M E N U
T E S T
(PAUSE) key to switch to PAUSE mode.
(NEXT) or
A D V A N C E D F U N C .
(ENTER) key, and then press the
until the following menu is displayed.
S O R T
(ENTER) key to display the sorting setting menu.
S O R T
Press or key to select "ON" or "OFF", and then press the
key to confirm. To cancel the selection, press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• This setting is retained in the memory even when the power is turned off.
• If data for which the cutting/plotting sequence has been set using the application
software is received, the cutting/plotting sequence may be changed if this function is set
to "ON." The function should be set to "OFF" in this case.
(PREV.) key until the following menu is displayed.
O F F
Function Settings and Operations
(NEXT) or (PREV.) key
(ENTER)
(NEXT) or (PREV.) key.
4-21