Appendix A Main Specifications - GRAPHTEC CE5000-120AP User Manual

Appendix

Appendix A Main Specifications

CPU
Configuration
Drive system
Maximum cutting area
Maximum guaranteed cutting area 1164 mm x 3 m*
Compatible media
Media widths
Maximum roll outer diameter
Media types
Maximum cutting speed
Specifiable cutting speeds
Cutting force
Mechanical resolution
Programmable resolution
Repeatability precision
Mechanical precision
Guaranteed precision
No. of pens mountable
Compatible cutter blade type
Compatible pen type
Interfaces
Buffer capacity
Command modes
Display panel
Rated power supply
Power consumption
Operating environment
Conditions for guaranteed precision
External dimensions (W x D x H)
Weight
*1: When the following Graphtec-specified conditions have been met:
• Graphtec-specified paper must be used for cutting/plotting.
• "PAPER LOAD: 2" must be specified for the PAPER LOAD setting and "UNTIL: 180 seconds" for the PAPER
READY TIME setting.
• After five pages have been cut/plotted consecutively, the paper must be reloaded.
• If expansion or contraction of the paper due to temperature and/or humidity changes has occurred during
a cutting or plotting operation, the following margins of error are added to the repeatability precision value:
0.1 mm/
*2: The precision specification is the precision that was obtained when Graphtec's mylar film was used to
measure the mechanical precision. Please note that as only fine quality pattern paper can be used with this
device, the precision may differ slightly.
*3: HP-GL™ is a registered trademark of Hewlett-Packard Company.
A-2
Item
32-bit
Grit-rolling
Digital servo
1164 mm x 50 m
160 to 270, 300 to 400, 440 to 540, 580 to 680, 710 to 810, 850 to 950,
990 to 1090, 1120 to 1220 mm (the effective cutting/plotting area is the
maximum obtainable area for the corresponding medium width)
Up to 1180 mm when roll media (2-inch core) is used
190 mm
Fine quality paper for apparel patterns (64 to 130 g/m
Roll media diameter: 2-inch, 3-inch
60 cm/s
1 to 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 cm/s
20 to 300 gf, 31 levels
0.005 mm
GP-GL: 0.1/0.05/0.025/0.01 mm, HP-GL
Within 0.1 mm/3 m*
Within ±0.5 mm/3 m, up to a maximum of five consecutive pages*
(cutter pen/plotter pen exchange precision is also included)
2
Supersteel
Water-based fiber-tip pens, Oil-based ballpoint pen
RS-232C/USB 2.0 (Full speed)
2 MB
GP-GL, HP-GL
LCD (16 characters x 1 row)
100 to 240 VAC, 50/60 Hz
100 VA
10 to 35°C, 35 to 75% RH (non-condensing)
18 to 28°C, 45 to 65% RH (non-condensing)
Approx. 1487 x 1020 x 1189 mm
Approx. 43 kg
°
C, 0.3 mm/10% RH.
CE5000-120AP
1
TM
2
TM 3
* (control-panel selectable)
2
)
3
* : 0.025 mm
1