Christie D4KLH60 Mirage 4KLH User Manual page 49

Issue
Interlock cannot be reset
Interlock opens
D4KLH60/Mirage 4KLH User Manual
020-101375-02 Rev. 1 (06-2015)
Resolution
• If the projector is in standby, check the status of the RGB Sensor board. In
the left pane, tap Menu > Status > RGB Sensor. If it is offline, press and
hold the power button to put the projector in power on mode and press
Manual Reset on the projector. Contact Christie support.
• Make sure the wall breaker providing AC to the Laser Rack is on.
• Make suer the laser system network switch in the Laser Rack is on.
• Make sure the laser beam stop is in the open position.
• Make sure the key switch on the Laser Rack is in the ON position.
• Make sure the emergency stop buttons on the projector and the Laser Rack
are released.
• Make sure a fiber optic cable is properly attached to each laser module and to
the projector.
• Make sure the interlock cables to the Interlock In and Interlock Out
connectors on each laser module are properly attached. Ensure the interlock
cable is properly attached to the Laser Interlock connector on the projector.
• Make sure one end the 25-pin interlock cable is properly attached to the
interlock harness on the Laser Rack and the other end to the Laser Rack
connector on the projector.
• Check the DMD temperatures. See
46.
• Make sure that the lasers were not turned off from the laser bank control
application.
• Check the interlocks. See
DMD over-temperature warning
Interlock cannot be reset
Troubleshooting
on page
on page 49.
49