Christie D4KLH60 Mirage 4KLH User Manual page 45

Maintenance
1. Tap and hold the red power button
2. Disconnect the projector from AC power or turn the circuit breaker off.
3. Install the lens cap and turn the lens clamp to the open position.
4. If necessary, remove the 2 cap screws securing the lens to the lens mount using a hex key.
5. Pull the lens out of the lens mount and then install a small lens cap on the rear of the lens.
6. Remove the small rear cap from the new lens. Keep the front cap on.
7. Align the tabs on the lens plate with the lens mount. Insert the lens until it connects with the
magnets on the mount. When the lens contacts the magnetic plates it is seated correctly.
8. Secure the lens clamp by rotating it clockwise.
9. Tighten the lens mount cap screws for added stability.
10. Remove the lens cap from the front of the lens.
45
on the TPC Main panel to turn the projector off.
D4KLH60/Mirage 4KLH User Manual
020-101375-02 Rev. 1 (06-2015)