Removing Pci Add-In Boards; Figure 42. Installing Pci Add-In Board - Intel SC5650-DP Service Manual

Hardware Installations and Upgrades
7. Hold the PCI add-in board by its top edge or upper corners. Firmly press the add-in
board into an expansion slot on the server board (see letter "A" in the following
figure). Close the back panel PCI Add-in Card Retention Device (see letter "B").
8. Repeat the previous steps until all PCI add-in boards are installed.
9. Attach cables, if necessary.
10. Reinstall the left side cover. For instructions, see
11. Reconnect all peripheral devices and the AC power cable. Power up the server.

Removing PCI Add-in Boards

Caution: PCI add-in boards can be extremely sensitive to electric static discharge (ESD) and
always require careful handling. After removing the add-in board from its protective
wrapper or from the server board, place it component side up on a grounded, static-free
surface or conductive foam pad. Do not slide the add-in board over any surface.
1. Observe the safety and ESD precautions listed in
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see
38
B
B

Figure 42. Installing PCI Add-in Board

A
TP01745
"Installing the Left Side
Appendix A, "Safety
"Removing the Left Side
®
Intel Chassis SC5650-DP/WS/BRP/UP Service Guide
Cover".
Information".
Cover".