Installing Feet For A Pedestal-Configured Chassis; Figure 75. Installing Feet On Chassis - Intel SC5650-DP Service Manual

Installing Feet for a Pedestal-configured Chassis

Note: Do not install feet on your Intel
Only install feet on a pedestal-configured chassis.
1. Observe the safety and ESD precautions listed in
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Lay the chassis down on its right side.
4. Insert rubber foot into chassis hole (see letter "A" in the following figure). Secure foot
to chassis by inserting a pin through the rubber foot (see letter "B"). Repeat process
for remaining feet.
5. Put chassis in the upright position.
6. Reconnect all peripheral devices and the AC power cable to the server. Power up the
server.
®
Intel Chassis SC5650-DP/WS/BRP/UP Service Guide
®
Server Chassis SC5650 if it is to be installed in a rack.
A
B

Figure 75. Installing Feet on Chassis

Hardware Installations and Upgrades
Appendix A, "Safety
TP01709
Information".
59