Hardware Installations and Upgrades
6. Insert the CD-ROM or DVD-ROM drive into the 5.25-in device drive bay (see letter
"C" in the following figure). Line up holes in CD-ROM drive with holes in chassis
(see letter "D"). Move latch to the "lock" position (see letter "E"). Connect power (P5
or P6connector from the power supply. An additional 4-pin IDE male-to SATA 15-
poin power cables adapter may be needed if the CD-ROM or DVD-ROM does not
have a 4-pin power connector.) and data cables to the rear of the CD-ROM or DVD-
ROM drive (see letter "F").
Figure 37. Installing CD-ROM or DVD-ROM Drive (DP/WS/BRP configuration shown)
7. If necessary, remove the filler panel from the front bezel assembly.
34
TP01723
®
Intel
Chassis SC5650-DP/WS/BRP/UP Service Guide