Upper Panel - Sony SRW-9000PL Operation Manual

Set the input selection switches according to the
type of the connected signal source.
LINE: When a line-level (+4 dBu) signal source
is connected
MIC: When an external microphone is connected
(no power is supplied.)
MIC +48V ON: When an external microphone is
connected (+48 V power is supplied.)
j HD SDI OUT A/B connectors (BNC
type) and ON/OFF switch (when the
HKSR-9001 is installed)
When the switch is set to ON, HDSDI signals are
output from the A and B connectors. When the
switch is set to OFF, no signals are output.
See "What Are Dual Link and 3G?" (page 212) for
more information about HDSDI signal output.
k REMOTE connector (8-pin)
Connect an external control device, such as the
RM-B150/B750 Remote Control Unit.
l AUX IN (auxiliary input) connector
(BNC type) (when the HKSR-9001 is
installed)
1.5G single link (4:2:2 30PsF or less) HDSDI
signals can be input to this connector and
recorded. Connect an external device to increase
the number of audio input channels, or to
synchronize this unit to the output of an HD
device.
When you use this connector for HDSDI input,
set SYSTEM Setup >FORMAT >INPUT SEL
(see page 180) in the VTR menu to AUX Input.
m HD SDI MON2 (HDSDI monitor
output 2) connector (BNC type)
Use in the same way as the HD SDI MON1
connector on the left-side panel (see page 17).
20 Locations and Functions of Parts

Upper Panel

Control panel
(page 21)
With control panel detached
a Lock release button
When removing the control panel, use this button.
For details, see "Attaching the Control Panel" (page
37).
b Handle
Use to carry the unit.
You can attach an accessory to the seven screw
3 1
holes ( / " × 4, / " × 3) on the top of the handle.
8 4
You can also attach the CAC-12 Microphone
Holder to the side of the handle.
For details, see "Using a Microphone" (page 34).
c Assistant panel attachment screws
Attach the optional AP-1 Assistant Panel or the
CAC-12 Microphone Holder.
For details, see "Attaching the AP-1 Assistant Panel
(Optional)" (page 39) or "Using a Microphone"
(page 34).
d Cable holder attachment screws
Attach the supplied cable holder to hold the cable
of the control panel or the optional AP-1 Assistant
Panel.
e Accessory attachment screw holes
You can attach accessories to the two screw holes
3 1
( / " × 1, / " × 1).
8 4