Sony SRW-9000PL Operation Manual page 109

The S in S59P indicates that SR Motion is
enabled (SELECT FPS is set to "ON"). The
59P indicates that FPS FORMAT is set to
59.94P. (23PsF) indicates that the target
frame frequency setting is 23.98PsF.
To make the timecode continuous
Make the following settings in the TC Setup
menu.
RUN MODE: R RUN (Rec Run)
TCG MODE: PRST (Preset) or RGN
(Regen), both are available.
REGEN SOURCE: INT L (Internal LTC)
(following the timecode recorded on the
tape)
For details on the TC Setup menu, see "TC
(Timecode) Setup Menu" (page 173).
2
Set the number of frames to shoot.
1 While holding the FUNC button down,
press the SELECT/ENTER dial.
2 Turn the SELECT/ENTER dial to set
the number of frames to shoot. (The
setting range is 1 to 60 FPS.)
Playback speed
Number of frames (FPS)
To confirm the new setting, press the
SELECT/ENTER dial or leave it unrotated
for three seconds. The display returns to the
original screen. A screen like the one shown
below appears if you hold down the FUNC
button and press the SELECT/ENTER dial
again while the above screen is displayed.
This new screen remains even if three
seconds pass with no operation. While this
screen is visible, you can check the setting
that specifies the number of frames to shoot.
To do so, hold down the FUNC button and
press the HOME button. The signal format
display at the bottom of the screen changes
into the SR Motion display, allowing you to
check the number of frames setting.
You can also change the number of frames as
you are shooting (Ramp function). For details,
see "Using the Ramp Function" (page 111)
3
Start shooting.
1 Check the timecode of the current
position (make a memo), so that you
will be able to rewind after shooting.
Select FPS Function 109