Table of Contents
Advertisement
UNI is shown for channels whose recording
levels have not been changed.
3
Turn the SELECT/ENTER dial to
select UNI/VAL, and press the dial.
If you do not need to change the recording
level, set the recording level of the channel
selected in steps 1 and 2 to UNI and proceed
to step 5. If you do need to change the
recording level, set the recording level of the
channel selected in steps 1 and 2 to VAR and
proceed to step 4.
4
Turn the ADJUST knob to set the
recording level.
Turn clockwise to raise the level and turn
counterclockwise to lower it.
To reset the setting
Turn the SELECT/ENTER dial to move the
cursor to RESET, and press the dial.
5
Press the SELECT/ENTER dial.
6
Repeat steps 1 and 2 to select other
channels and steps 3 and 4 to set the
recording levels of those channels.
7
When you are finished, turn the
SELECT/ENTER dial to select END,
and press the dial.
Making Timecode and User Bits
Settings
Use the VTR >TC Setup menu to make timecode
and user bits settings.
To display the TC Setup menu
Press the menu selection button "TC".
TC button
TC Setup menu screen
Control panel
To select the type of time data to display
Use the TIMER SEL item.
1
2
To select timecode to record
You can select the following types of timecode.
Menu item
TCG
MODE
PRST
RGN
SELECT/
ENTER dial
Turn the SELECT/ENTER dial to
select CTL, TC (timecode), or UBIT
(user bits).
CTL: Display CTL signals.
TC: Display timecode.
UBIT: Display user bit data.
Press the SELECT/ENTER dial.
Timecode
REGENE
SOURCE
–
An arbitrary initial
timecode value can be
preset (R RUN/F RUN
and DF/NDF menu
items can be set to any
values).
INT L
Timecode in
synchronization with
the timecode recorded
in the longitudinal
direction on the tape.
EXT L
Timecode in
synchronization with
the timecode input to
the TC IN connector.
a)
Timecode in
AUX L
synchronization with
the LTC timecode of the
SDI signal input to the
AUX IN connector.
Recording
89
Advertisement
Table of Contents
