Sony SRW-9000PL Operation Manual page 91

5
Turn the SELECT/ENTER dial to
move the cursor to SET, then press the
dial.
If RUN MODE is set to F RUN, the timecode
starts advancing immediately.
To set all digits to 0
Reset the timecode value with the TIMER
RESET menu item.
To set the timecode generator value to
XX:00:00:00
You can set the current timecode generator value
to the "00:00:00" value of the next hour.
Example: TCG 01:12:34:12 t TCG 02:00:00:00
You can perform this setting from the control
panel or the subdisplay/menu operations section.
• Performing the setting from the control
panel
Press the TC button while holding the FUNC
and BACK buttons down.
• Performing the setting from the subdisplay/
menu operations section
When the TCG is displayed in the subdisplay,
press the SET button while holding the MENU
SEL/ENTER dial down.
To synchronize the internal timecode generator
to external timecode
Use the following method to synchronize the
timecode generators of multiple camcorder.
Set the TCG MODE menu item to RGN, then use
REGENE SOURCE to select the signal which the
timecode generator should regenerate (see "To
select timecode to record" (page 89)).
To record user bits
By setting user bits, you can record up to eight
hexadecimal digits of information (date, time,
etc.) in timecode tracks.
To record user bits after setting an arbitrary
value
Set OTHERS (MAIN) >RT REC to OFF.
To initialize user bits to an arbitrary value, set the
TCG SET (MAIN) >UBG SOURCE menu item
to INT. (The TCG MODE menu item can be set
to any value.)
Alternatively, set the TCG MODE menu item to
PRST. The TCG SET (MAIN) >UBG SOURCE
menu item can be set to any value (see "To select
user bits to record" (page 90)).
To set the user bit value, proceed as described in
"To preset an arbitrary initial timecode value". As
with timecode, all digits in user bit values can be
set to 0 by using the TIMER RESET menu item.
To record real time in user bits
Select the recording method with OTHERS
(MAIN) > RT REC (VITC only, both VITC and
LTC, or LTC only). Regardless of the setting of
TCG SET (MAIN) >UBG SOURCE, real time is
recorded in the specified location.
To set the real time to record, proceed as follows.
1
Turn the SELECT/ENTER dial to
select RT SET, and press the dial.
The real time setting window appears.
2
Turn the SELECT/ENTER dial to
move the cursor to the digit you want to
change, and press the dial.
3
Turn the SELECT/ENTER dial to
change the value of the selected digit,
and press the dial.
4
Repeat steps 2 and 3 until the desired
value is displayed.
5
Turn the SELECT/ENTER dial to
move the cursor to SET, and press the
dial.
Tele-File recording
This system records the following Tele-File data
to cassette labels with each recording operation.
• IN (recording start point)
• OUT (recording end point)
• Tape Format
• Duration (time from In point to Out point)
• File Name (automatically assigned file name in
the format HDCAMSR_00X)
Note
TeleFile data may not be saved correctly if the power
ON/OFF switch is set to the OFF position within one
second after the end of recording.
When the number of files exceeds 70
Old files are deleted before new files are added.
To delete all or selected files, use the SRW-5000/
5500 to format the memory label or carry out a
file deleting operation.
Recording 91