Table of Contents
Advertisement
Warning System
When an error is detected immediately after the unit is powered on, or during operation, an message
appears (see A in the following table) on the viewfinder screen, on an external monitor, in the subdisplay
on the right-side panel, and in the control panel display, and the tally indicator (see page 19) flashes (see
B in the following table) to alert you to the error. In addition, warning and alarm tones are output from the
EARPHONES jack and the buzzer mounted on a circuit board inside the unit (see C and D in the following
table).
Notes
• Warning tones are not output unless BEEP(PHONE)/BEEP(BOARD) >WARN in the VTR >AUDIO Setup menu (see
page 178) is set to HIGH or LOW.
• Alarm tones are not output unless BEEP(PHONE)/BEEP(BOARD) >ALARM in the VTR >AUDIO Setup menu (see
page 178) is set to HIGH or LOW.
Layout of the table of warning messages
Message
A
Problem
• The operation of the tally indicator is represented by graphic symbols as follows.
: 1 flash/s
: 4 flashes/s
• The warning and alarm tones are represented by graphic symbols as follows.
: 1 beep/s
: 4 beeps/s
: Continuous beep
Warning indications/tones
Message
See "Warning
messages" (page 205).
Problem
A warning message
condition occurred
(excepting "0060
LOST LOCK"
described below).
Message
0060 LOST LOCK
Problem
Servo lock lost during
recording.
200
Warning System
Tally indicator
B
Operation on the VTR module
Tally indicator
–
Operation on the VTR
module
Continues operation.
Tally indicator
a)
Operation on the VTR
module
Recording continues, but
the results may be invalid.
Warning tone
C
Action to take
Warning tone
–
Action to take
Check the warning message, and resolve the condition,
referring to the "Description" column in the table of
"Warning messages" (page 205).
Warning tone
b)
Action to take
Turn off the power and contact a Sony service
representative.
Alarm tone
D
Alarm tone
–
Alarm tone
–
Advertisement
Table of Contents
