Display - Sony SRW-9000PL Operation Manual

Display

When you press the HOME button with the
FUNC button held down, sections 4 to 7 are
replaced by the display shown in section 9.
This manual refers to the screen shown below as
the HOME screen.
a Audio level meters
Display recording audio levels in recording and
E-E modes. Display playback audio levels during
playback.The indications in the top row show the
audio input signal types.
The numbers 1 to 12 at the bottom are the
numbers of audio tracks on the tape.
26 Locations and Functions of Parts
b Operation status and warnings
Display the operation status of the unit and
warnings. The principal information items are as
follows.
TCR/TCG/UBR/UBG/CTL: Type of time data
being displayed.
LTC/VITC: When timecode is being displayed,
whether it is LTC or VITC.
INTRP: Indicates that timecode could not be
read accurately, and has been interpolated.
DF/NDF: Whether the system is in DF (drop
frame) or NDF (non-drop frame) mode.
EXT-LK: Timecode is locked to external
timecode.
KEY INHI: The KEY INHI switch is set to ON.
REC INHI: The cassette is record inhibited.
SRW-9000PL(E) or SRW-9000(PL,E): Model
name display. When the optional HKSR-
90PL Upgrade Kit is installed on the SRW-
9000, "SRW-9000(PL,E)" is displayed.
"E" shows that an enhanced processor is
installed, which allows recording in RGB
4:4:4 or 4:4:4 HQ 12bit format and using S-
LOG gamma.
When SYSTEM Setup >FORMAT >INPUT
SEL in the VTR menu is set to "AUX Input"
with the optional HKSR-9001 installed, the
indication changes as follows.
SRW-9000(E)t9000(E)AUX
SRW-9000(PL,E)t9000(PL,E)AUX
[1]/[2]: Option board installation status. "1"
represents the HKSR-9001, and "2"
represents the HKSR-9002.
1) VITC (Vertical Interval Time Code): Timecode
inserted into the vertical blanking interval. This type
of timecode can be read even during very slow
playback.
For details on warnings, see "Warning/Error
Messages" (page 202).
c Time data
Displays time data for the current tape position.
The type of time data is CTL
time), timecode, or user bits, as selected with TC
Setup >TIMER SEL in the VTR menu (see page
173).
When Mark In data has been set by the FUNC +
REC buttons or SYSTEM Setup >EDIT >IN
POINT in the VTR menu, it is displayed in the
format "IN: xx:xx:xx:xx" beneath (right side) the
time data for the current tape position.
1)
1)
(tape running