Positions Of The Brackets; Plywood Base For A Wall With Wooden Studs; Figure 32: Bracket Positions On The Switch - Allied Telesis AT-GS924MX Installation Manual

Chapter 4: Installing the Switch on a Wall
Positions of the
You should install the two brackets diagonally across from each other on
the sides of the switch. Allied Telesis recommends installing the bracket
Brackets
for the front panel above the chassis and the bracket for the back panel
below the chassis. See Figure 32.
Bracket
Bracket
Bracket
Bracket
Figure 32. Bracket Positions on the Switch
Plywood Base for
If you are installing the AT-GS924MPX, AT-GS948MX, and
AT-GS948MPX Switch on a wall that has wooden studs, Allied Telesis
a Wall with
recommends using a plywood base to attach the device to the wall. (A
Wooden Studs
plywood base is not required for a concrete wall.) See Figure 33 on page
79.
78