Figure 36: Attaching The Brackets For Wall Installation For All Switches Except The At-Gs924Mx Switch - Allied Telesis AT-GS924MX Installation Manual

1. Perform Step 1 to Step 3 in "Installing the Switch in an Equipment
Rack" on page 62 to remove the rubber feet from the bottom of the
switch.
2. Install the two brackets diagonally across from each other on the sides
of the switch, with the eight bracket screws included with the device.
See Figure 36.
Positions of the brackets if the switch is to be
installed on the wall with the front panel on the left.
Position of the brackets if the switch is to be installed
on the wall with the front panel on the right.
Figure 36. Attaching the Brackets for Wall Installation for All Switches
Except the AT-GS924MX Switch
3. Have another person hold the switch on the plywood base on the wall
while you secure it with the two provided screws. See Figure 37 on
page 84.
As you position the switch on the wall, be sure to leave sufficient space
from other devices or walls so that you can access the front and back
panels. Refer to "Recommended Minimum Wall Area Dimensions" on
page 76.
AT-GS900MX Series Installation Guide for Stand-alone Switches
83