Switch Id Led; Figure 12: Switch Id Led; Table 10: S1 And S2 Slot Leds - Allied Telesis AT-GS924MX Installation Manual

Switch ID LED

Table 10. S1 and S2 Slot LEDs
LED State
Link/Activity Off
Solid green
Flashing
green
The Switch ID LED, shown in Figure 12, displays the ID number of the
switch. A stand-alone switch has the ID number 0. Switches in a VCStack
have the numbers 1 to 4. Chapter 6, "Powering On the Switch" on page 97
has the procedure for verifying and, if necessary, changing the ID number
of the switch.
The states of the LED when the switch is not operating in the low power
mode are shown in Figure 13 on page 44.
AT-GS900MX Series Installation Guide for Stand-alone Switches
Description
The slot is empty, the stacking transceiver
has not established a link to a network
device, or the LEDs are turned off. To turn
on the LEDs, use the eco-friendly button.
The stacking transceiver has established
a link to another switch in the stack.
The stacking transceiver is receiving or
transmitting packets.
Switch ID LED
Figure 12. Switch ID LED
43