Adjusting The Support Angle - Otto Bock Motus CV Instructions For Use Manual

Settings
2) Adjust the lower leg length (continuously adjustable) (not illustrated). Ensure that the tube foot support is inser­
ted at least 40 mm into the leg support holder.
INFORMATION: A mark on the tube foot support indicates the minimum distance the tube foot sup­
port must be inserted during assembly.
3) Tighten the Allen screw to 7 Nm.
51
"Elevating" leg support on Motus CV
1) Loosen the Allen screw on the leg support (see fig. 52). Then the tube foot support can be moved as needed.
2) Adjust the tube foot support to the desired lower leg length.
3) Tighten the Allen screw to 7 Nm.
52

6.7.2 Adjusting the support angle

The leg support angle setting should be chosen so that the ankle is in a relaxed, comfortable position.
Single panel footplate
1) Loosen and remove the Allen screw on the foot plate suspension on the left side (see fig. 53, item 1).
2) Turn the foot plate to the desired angle.
3) Tighten the Allen screw to 8 Nm.
24 Motus CV, Motus CS