Scon Header (J7); Pmc/Ipmc Selection Headers (J10, J15 - J18, J25 - J28) - Motorola MVME6100 Installation And User Manual

SCON Header (J7)

A 3-pin planar header allows the choice for auto/enable/disable SCON VME configuration. A
jumper installed across pins 1 and 2 configures for SCON always enabled. A jumper installed
across pins 2 and 3 configures for SCON disabled. No jumper installed configures for auto
SCON.
1
2
3
Auto-SCON
(factory configuration)
PMC/IPMC Selection Headers (J10, J15 – J18, J25 – J28)
Nine 3-pin planar headers are for PMC/IPMC mode I/O selection for PMC slot 1. These nine
headers can also be combined into one single header block where a block shunt can be used
as a jumper.
A jumper installed across pins 1 and 2 on all nine headers selects PMC1 for PMC I/O mode. A
jumper across pins 2 and 3 on all nine headers selects IPMC I/O mode.
J10
1 1
2 2
3 3
J10
1 1
2 2
3 3
J7
1
2
3
Always SCON
IPMC P2 I/O for IPMC Mode
(factory configuration)
J15 J16 J17
1 1 1
2 2 2
3 3 3
PMC1 P2 I/O for PMC Mode
J15 J16 J17
1 1 1
2 2 2
3 3 3
Chapter 1 Hardware Preparation and Installation
J7 J7
1
2
3
No SCON
J18 J25 J26
1 1 1
2 2 2
3 3 3
J18 J25 J26
1 1 1
2 2 2
3 3 3
MVME6100 Installation and Use (V6100A/IH2)
J27 J28
1
2
3
J27 J28
1
2
3
7