Procedures To Install Windows Into Internal Hdd/Ssd; Presetting; Preparations For Installation - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software

4.4 Procedures to install Windows into internal HDD/SSD

4.4 Procedures to install Windows into internal HDD/SSD
This section briefly describes the procedures by which Windows is installed in the internal HDD/SSD. Start the installation
after checking the MMB configuration and successful to log in to the MMB.

4.4.1 Presetting

If necessary, the following settings are done.
1. Remove each built-in HDD that is not the installation destination.
2. The setting of partition is checked by MMB.
- Setting of configuration of SB/IOU
See "3.4.1 Setting the partition
- Setting of Console Redirection
See "3.4.6 Settings of Console
- Video redirection: Enable
- Virtual media: Enable
- Setting of various modes
See "3.4.5 Various mode
3. [PCI ROM Priority] of BIOS is set.
- For the UEFI Install
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "EFI Compatible
ROM".
- For the Legacy Install:
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "Legacy ROM".
- Set [Device Manager]-[PCI Subsystem Configuration]-[OpROM Scan Configuration] of BIOS menu to "Enable"
only for booting Device.
4. The I/O space is allocated in the SAS card and in the SAS RAID controller card.
For details on allocation of I/O space, see
menu" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).

4.4.2 Preparations for installation

The following preparations are done.
1. The following disk images are prepared.
Media of Windows operating system
2. Remove all FC cables.
3. Mount the following disk image by connecting the video redirection.
4. Change the boot order, and set DVD Boot to the top priority of the starting order.
For details, see "1.3.1 [Power Control] window" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
configuration"
Redirection"
settings"
"3.4.5 Various mode
65
settings" and [Configure I/O Space Assignment]
CA92344-0536-04