Figure 5.9 Dump Device Selection Menu - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 5 Work after Operating System installation
5.3 Setting of sadump
9. Select the disk or the disk partition, and set the disk or the disk partition where the dump device is to be configured.
The dump device selection menu is displayed.
(Data corruption)
When the dump device is selected, reconfirm whether the selection of disk is correct. If the operation is executed with
an incorrect disk selection, data would be corrupted.
Remark
For the ACPI name that shows the disk or the disk partition, see "3.6 Device Path" of PRIMEQUEST 2000 series Tool
Reference (CA92344-0539).
Press [Enter] key.
10.
The dump device is created. Return to dump device configuration menu.
Warning
When the dump device is created, it is initialized. Depending on the size of the selected disk or that of
the disk partition, the time required for initialization would be different. In some cases, it takes time for
initialization, and then it takes a few minutes or more to change to the next window.
FIGURE 5.9 Dump Device Selection Menu
93
CA92344-0536-04