Setting Ntp Server; Figure 6.3 Example Of [Date/Time] Window - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 6 Work after installation
6.2 NTP Configuration

6.2.2 Setting NTP server

Other NTP server which is time synchronous is specified by using the NTP client function of the MMB.
Note
Time of MMB and time of partition side is controlled by the respective independent clocks. Clock of MMB does not repot
and adjust the partition clock. Since the time of MMB and time of partition, are necessary for following responses, keep the
MMB time and the partition time the same or at least close.
- At the time of comparing the MMB side log and the operating system side log in partition by the hard failure
- At the time of executing the system inspection or executing the security inspection
- When alarm occurs in the time maintenance battery of the partition side.
Execute any of the following ways to adjust the time.
- Set the time manually from the MMB Web-UI
- Set the time by using the NTP client function of the MMB
Remark
Set the time on Operation System if NTP is not used.
Operations
1. Click [Networking configuration] – [Date/Time].
→ [Date/Time] window is displayed. For the details of [Date/Time] window, see "1.5.1 [Date/Time] window" of
PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
2. Click [Enable] for [NTP].
3. Select [NTP Time Correction Mode].
4. Enter IP address of other NTP server.
NTP Server 1: Specify NTP server.
NTP Server 2: Specify NTP server.
NTP Server 3: Specify Other (Tertiary) NTP server.
5. Click [Apply] button.
MMB synchronizes with NTP server and time set in NTP Server 1 ~ NTP Server 3.
6. After few minutes click [Refresh] button and confirm whether the correct time is displayed.
FIGURE 6.3 Example of [Date/Time] Window
106
CA92344-0536-04