Chapter 4 Installation Of Operating System And Bundled Software; Installation Procedure Of Operating System And Bundled Software; Install Procedure Of Operating System To Extended Partition - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software

4.1 Installation procedure of Operating System and bundled software

CHAPTER 4
The installation method of operating system and the bundled software is explained here.
All the inserted windows are examples of display and the contents displayed by the system configuration, etc. are different.
4.1 Installation procedure of Operating System and bundled
software
When Boot Watchdog is enabled, during installation operation, partition reset may occur unpredictably by Boot Watchdog
function. Therefore, Boot Watchdog is cancelled before operating system is installed. For the cancellation method see
"9.4.1 Automatic reboot condition setting of partition" of PRIMEQUEST 2000 series Administration Manual (CA92344-
0537). SVIM(ServerView Installation Manager) is used to install operating system in the partition of PRIMEQUEST 2000
series. SVIM is a setup support tool to execute the below mentioned operations.
- Installation of operating system
- Installation of driver necessary for the operating system
- Installation of the bundled software
For the software which is automatically installed by using SVIM see "3.3 Bundled software" of PRIMEQUEST 2000 series
General Description (CA92344-0534).
For SVIM outline see ServerView Suite ServerView Installation Manager.
Moreover, there are points to be noted for SVIM. See the list of points to be noted for the PRIMEQUEST 2000 series
ServerViewSuite .
Notes
Confirm the installation of SAN boot environment, installation of VMware as follows.
- Configuration of SAN boot environment
When SAN boot environment is to be installed, the SAN boot environment is configured before the operating system
is installed.
For the construction of SAN boot environment, see PRIMEQUEST 2000 Series SAN Boot Environment
Configuration Manual.
- When the installation VMware of operating system and the bundled software is to be installed then the procedure is
different. For Notes on VMware installation, see
Notes
Disable Secure Boot before you install OS.
Secure boot is set by BIOS menu. Initial value of secure boot is "disabled". Please see PRIMEQUEST 2000 Series Tool
Reference for setting method of secure boot.
4.2

Install procedure of Operating System to Extended Partition

Here, points to be noted for the procedure to install Operating System to Extended Partition.
- Virtual Media is available to only one Extended Partition of PPAR Partition if VGA/USB2 is assigned to the Extended
Partition. Therefore, when OS is installed with another Extended Partition on the same PPAR partition after installation
of OS, it is necessary to power OFF the PPAR partition and reassignment of VGA/USB2 to the Extended Partition
which carries out OS installation.
Please release of VGA/USB2 to the Extended Partition after OS installation.
- Before installing the OS, assign a VGA/USB2 temporarily to the relevant extended partition.
In the case of the extended partition which is not assigned a VGA, the serial interface is required.
Fixed as follows:
Installation of Operating System
and bundled software
"Appendix D Notes on VMware
60
installation".
CA92344-0536-04