Configuring Bundled Software After Installation; Figure 4.2 File Structure - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software
4.6 Procedure to install RHEL into internal HDD/SSD

4.6.4 Configuring Bundled Software after Installation

Bundled software is configured after installing the operating system.
1. The trap destination from the partition is configured.
Remark
Configuring of the trap destination can be checked by using standard trap for SNMP service. For details, see "6.5.2
Configuring SNMP".
2. The trap destination and Mail destination through MMB are configured.
In linkage with operations management software, it is configured only if necessary.
- Configuring SNMP trap destination through MMB
See "6.5.2 Set up of
- The report destination and the filter are set when Alarm E-Mail is configured.
See "3.3.9 Set up of Alarm
3. OneCommand Manager is installed while installing FC card.
a. By executing the following command, the libnl package information is displayed. Confirm that libnl is installed.
# rpm -qi libnl
If libnl is not installed, search libnl package in installation media of distribution, and install libnl package by
executing the following command.
# rpm -ivh libnl-<version>-<release>.<arch>.rpm
Remark
Read the part of <version>, <release>, <arch> properly.
b. Download the driver/utility of FC Card from the following URL.
http://support.ts.fujitsu.com/
Note
Though PRIMERGY is described in the downloaded binary, driver/utility can be used by the PRIMEQUEST
2000 series.
c. The file to be downloaded is copied in an arbitrary directory of the PRIMEQUEST 2000 series and then
extracted.
tar xvzf F1010350.tar.gz
d. The file given below is extracted.
Remark
For the method of installing "SNIA HBA API library", see readme.txt extracted under HBA_API_LIB.
e. Reboot the partition after installation.
SNMP"
E-Mail"
File Structure
FIGURE 4.2
75
CA92344-0536-04