Various Mode Settings - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 3 Work before Operating System Installation
3.5 Partition Configuration (Extended Partitioning)

3.5.6 Various mode settings

Each mode of the Extended Partition is set.
Setting items of based on physical partition are shown below.
Although mode settings are shown in table below, some of the items cannot be done for each Extended Partition and they
are taken over by settings of relevant Physical Partitions. While items in this table can be set per Extended Partition, some
items have limitations for their setting. For details, please refer to remarks in this table.
Item unremarked in "Setting item" column is configurable item for Extended Partition.
For details on the respective settings in MMB, see " [Mode] window" of "1.3.9 [Partition#x] menu" of PRIMEQUEST 2000
series Tool Reference (CA92344-0539)
For details on the respective settings in UEFI, see "3.4 [Device Manager] menu" of PRIMEQUEST 2000 series Tool
Reference (CA92344-0539)
Note
- Confirm the I/O space is allocated in the SAS device (SAS card, RAID card, RAID card in DU or RAID card in SB) of a
relevant partition.
Further, also confirm the allocation of the I/O space to the FC card, onboard LAN and LAN Card (Only the card for the
boot passing), while installing on the SAN storage device.
SAS device is displayed as "Device: SAS", and the FC device is displayed as "Device: Fibre". When I/O space is not
allocated, operate [I/O Space Assignment Configuration] menu and remove the allocation of LAN and fibre channel.
However, do not remove the allocation of I/O space for the FC card onboard LAN and LAN Card used for installation,
when the operating system is installed for the storage in SAN environment.
53
CA92344-0536-04